All posts
For HomeownersBathrooms
5 min read

How to check your shower pan slope before tile goes in

A marble, a level, and a flood test. The 20-minute check that catches the most expensive bathroom mistake while it's still cheap to fix.

The shower pan is the most expensive thing in a bathroom to get wrong. Once tile goes on top of it, every mistake underneath is buried. A pan that holds water won't tell you for months. Then it shows up as a stain on the ceiling below, a soft floor, or a smell that never leaves.

The good news: the pan is easy to check while it's still exposed. You need a level, a tape measure, a marble, and about twenty minutes. Here's how.

What the slope should be

The standard target is 1/4″ of fall per foot, from every edge of the shower toward the drain. Plumbing codes and tile-industry guidance treat 1/4″ per foot as the minimum. Some installers go a little steeper. Very few good ones go flatter.

Do the math for your shower. If the far corner is 3 feet from the center of the drain, that corner should sit about 3/4″ higher than the drain. A 4-foot run needs about 1″.

Check 1: The marble test

Set a marble near each wall and each corner. It should roll toward the drain every time, without stalling. If it stops, or rolls toward a wall, that spot is flat or back-pitched. Water will sit there.

Check 2: Level and tape

Lay a 2-foot or 4-foot level on the pan, one end over the drain, pointing toward a wall. Raise the drain end until the bubble is centered. Measure the gap under that end. Divide by the length of the level in feet. That's your slope per foot. Repeat toward each wall and each corner.

Anything under 1/4″ per foot is worth a conversation. Anything that measures zero or negative is a stop-work problem.

Check 3: The flood test

Most waterproofing systems call for a flood test before tile. Plug the drain, fill the pan with water to just below the curb, mark the waterline, and leave it for at least 24 hours. Some jurisdictions require it as part of a pan inspection.

After the wait, the waterline should be exactly where you marked it. Check the ceiling or framing below, too. Any drop in level, any damp spot below, means the waterproofing has a hole. Fix it now. After tile, the fix is a demo.

Five more things to look at while the pan is open

  • The curb. Waterproofing should wrap over the top of the curb and down the outside face. No nails or screws through the liner on top of the curb.
  • Corners. Inside and outside corners are where liners and membranes fail. They should be folded or patched per the manufacturer, not cut and caulked.
  • The drain. On a traditional mortar bed, the drain has weep holes that must stay clear. If you can't see them, ask how they're protected.
  • Wall height. The waterproofing should run up the walls well above the curb. Check the membrane manufacturer's spec and compare.
  • Niches and benches. Every horizontal surface needs its own slope. A flat niche shelf collects water against the grout forever.

Take the photos now

Photograph the pan from every corner. Photograph the level with the tape under it. Photograph the flood test waterline at the start and the end, with something in frame that shows the time. These photos are the only record of the most important layer in the room.

If something looks off

Don't wait for the tile setter. Raise it with whoever built the pan, with your photos in hand. If you're not sure your reading is right, get a second opinion before the next layer goes on.

That's what a Professional Review is for. Upload your pan photos and measurements, and a vetted pro in the trade sends back a written Review with each concern pinned to your photos.$49. No referrals, no upsell, no connection to whoever did the work.

A Review is a visual observation of workmanship. It does not replace a municipal inspection or the waterproofing manufacturer's installation requirements.

Let Me Take A Look

Proactive construction QA. Written reviews from vetted pros.

Keep reading.

A vetted pro. On your build.

Upload your photos. Get a written Review back. $49.