All posts
For HomeownersNew Builds
6 min read

Pre-drywall walkthrough checklist: what to check and photograph

The last day you can see inside your walls. Framing, wiring, plumbing, blocking, and the photos that tell you where not to drill five years from now.

The week before drywall is the last time anyone will see the inside of your walls. Plumbing, wiring, blocking, insulation, framing. After the board goes up, all of it becomes a guess. Every problem you miss now costs a hole in a finished wall later.

You don't need to be a framer to walk the house. You need a plan, a phone, and an hour. Here's the checklist.

Before you walk

  • Ask whether the framing, rough plumbing, rough electrical, and mechanical inspections have passed. Ask to see the signed permit card.
  • Bring the plans, the electrical layout, and any change orders. You're checking the house against what you agreed to, not against memory.
  • Bring blue painter's tape and a marker. Tape marks every question so the crew sees it on site.

Framing

  • Sight down long walls. Bowed or twisted studs telegraph through drywall as waves. They're easy to swap now.
  • Check that doors and windows have proper headers, and that openings are where the plans put them.
  • Look for cut, notched, or bored joists and studs. Large notches near the middle of a joist span, or holes close to the edges, weaken it. Ask about anything that looks aggressive.
  • Confirm blocking is in for everything you'll hang later: TV mounts, grab bars, floating vanities, heavy shelves, cabinet runs, curtain rods.

Electrical

  • Walk every room with the electrical plan. Count outlets, switches, and light boxes. Check heights, especially over counters and vanities.
  • Confirm data, coax, speaker, and low-voltage runs are where you want them. Running them later means cutting into finished walls.
  • Look for cables stapled neatly and protected where they pass through framing close to the surface. Metal nail plates cover spots where a drywall screw could hit a wire.

Plumbing and mechanical

  • Check fixture rough-in locations against the fixtures you bought: shower valve height, toilet flange distance from the wall, vanity supply and drain height.
  • Look for nail plates where pipes run close to the face of a stud.
  • Confirm the shower valve is set at the right depth for the finished wall thickness. Too shallow or too deep and the trim kit won't fit.
  • Look at duct runs for crushed sections, open joints, and missing supports. Bathroom fans should vent outside, not into the attic.

Insulation and air sealing

  • Batts should fill each cavity with no gaps, compression, or voids behind outlet boxes.
  • Penetrations through top plates and exterior walls should be sealed. These are the drafts you'll feel for twenty years.

What to photograph

Photograph every wall in every room, floor to ceiling, with a sheet of paper in frame naming the room and wall (“Kitchen, north wall”). Take a wide shot, then close-ups of every plumbing run, junction box, and piece of blocking.

These photos do two jobs. Today, they're your record of what was built. Five years from now, they tell you where not to drill.

After the walk

Send your list to the builder in writing the same day, with photos. Ask for a written reply on each item before drywall is scheduled. Verbal “we'll take care of it” tends to get covered up.

If you want a trade pro to look at your photos before the board goes up, start a Professional Review. Upload your walk photos and a vetted pro sends back a written Review with every concern pinned to the exact photo. $49, with a short Q&A window included so you can ask follow-ups.

A Review is a visual observation of workmanship. It does not replace municipal inspections or a full on-site inspection.

Let Me Take A Look

Proactive construction QA. Written reviews from vetted pros.

Keep reading.

A vetted pro. On your build.

Upload your photos. Get a written Review back. $49.